A Topside company - serving West Hollywood, CA

Before & After Gallery - Topside Attic Insulation West Hollywood

Insulation Before & After in West Hollywood, CA

Photos don’t lie. In a city where contractors make big promises and deliver small results, we document every attic, every crawl space, every wall cavity. What follows are real jobs we’ve completed in West Hollywood and the surrounding hills. Each one includes a written price before we started, a Documented Photo Record when we finished, and on air-sealing jobs, before-and-after blower-door numbers you can hold in your hand.

Call (213) 306-2607

Recent Transformations

Attic Insulation Removal & Replacement - 1940s Spanish Colonial Near Sunset Strip

Before: compressed fiberglass and rodent debris in a West Hollywood attic. After: new blown-in cellulose at full depth with sealed top plates.
Attic insulation removal and replacement in a West Hollywood home built in 1942. Before photo shows original fiberglass batts compressed to less than 3 inches with evidence of prior rodent activity. After photo shows new blown-in cellulose at R-38 depth with all top plates and can-light penetrations sealed first.

The homeowner on North Sweetzer had been told by two other contractors to simply blow new insulation over the old. We found 70-year-old fiberglass compressed to R-6 equivalent, rodent droppings along the eaves, and unsealed top plates leaking conditioned air directly into the vented attic. Under Haven Standard Clause 1, we delivered a written scope: remove all existing material, sanitize the deck, seal every penetration with fire-rated caulk and rigid foam, then install GreenFiber blown-in cellulose to R-38. The blower-door test read 3,800 CFM50 before sealing and 2,100 after. The written price was $4,200. The crew left a Documented Photo Record and the 365-Day Done Right Promise in writing.

Crawl Space Encapsulation & Vapor Barrier - Hillside Home Above Fountain Avenue

Before: dirt crawl space with standing water and mold-stained joists in West Hollywood hills. After: sealed crawl space with 20-mil vapor barrier and closed-cell spray foam on rim joists.
Crawl space encapsulation in a hillside West Hollywood home with chronic moisture intrusion. Before photo shows unsealed dirt floor and mold-stained floor joists. After photo shows complete encapsulation with 20-mil reinforced vapor barrier and closed-cell spray foam on rim joists.

This 1962 hillside ranch above Fountain Avenue had a crawl space that smelled like a basement in Louisiana every January. The dirt floor wicked moisture uphill from the saturated soil, and the uninsulated rim joists were growing surface mold. We don’t encapsulate over active water, so we first coordinated with a drainage contractor to install a perimeter French drain. Then we laid a 20-mil reinforced vapor barrier with sealed seams and mechanical fastening at walls, applied 2 inches of closed-cell spray foam to all rim joists, and installed a commercial-grade dehumidifier set to 55% relative humidity. The homeowner received before-and-after moisture meter readings, a written price of $6,800, and the Documented Photo Record showing every seam and penetration. No more smell. No more mold.

Spray Foam Insulation - New Construction ADU on North La Cienega

Before: open stud walls and roof deck of a West Hollywood ADU under construction. After: continuous 3-inch open-cell spray foam on roof deck and 2-inch closed-cell on exterior walls.
Open-cell and closed-cell spray foam installation in a new-construction ADU in West Hollywood. Before photo shows open framing. After photo shows complete thermal and air barrier with continuous insulation at all corners and headers.

A local architect building a 420-square-foot ADU behind a duplex on North La Cienega specified continuous insulation with no thermal bridging. We applied 3 inches of open-cell spray foam to the roof deck for R-13 and an air-tight ceiling plane, and 2 inches of closed-cell spray foam to all exterior walls for R-14 plus structural rigidity. The combination eliminated thermal bridging at every corner, header, and stud bay. The blower-door test came in at 1.9 ACH50, well below the West Hollywood green building threshold of 3.0. Written price: $3,400. The architect now specifies this assembly on every ADU in the city.

Attic Air Sealing & Blown-In Insulation - Mid-Century Condo Near Melrose

Before: leaky attic with visible gaps around chimney chase and recessed lights in a West Hollywood condo. After: sealed penetrations with new blown-in fiberglass at proper depth.
Attic air sealing and blown-in insulation in a 1958 West Hollywood condo. Before photo shows unsealed chimney chase and non-IC-rated recessed lights leaking conditioned air. After photo shows sealed penetrations with fire-rated materials and new Owens Corning blown-in fiberglass to R-30.

The owner of a 16-unit building near Melrose and Fairfax called because her top-floor unit hit 89 degrees by 4 PM every August despite a new HVAC system. We found the attic hatch unsealed, a 4-inch gap around the masonry chimney chase, and twelve non-IC-rated recessed lights dumping conditioned air into the vented attic. Per the Haven Standard, we sealed first: fire-rated caulk and sheet metal around the chimney, Tenmat covers on every can light, and rigid foam on the hatch. Then we blew Owens Corning AttiCat fiberglass to R-30. The blower-door test dropped from 2,400 CFM50 to 1,550. Her August peak dropped to 76 degrees. Written price for her unit: $2,800. The HOA president requested proposals for the remaining 15 units the following week.

Radiant Barrier Installation - Flat Roof Retrofit Near Santa Monica Boulevard

Before: dark flat roof decking absorbing heat in a West Hollywood commercial building. After: radiant barrier foil stapled to roof deck with proper air gap above new blown-in insulation.
Radiant barrier installation in a 1970s flat-roof commercial building in West Hollywood. Before photo shows dark plywood roof deck with no reflective surface. After photo shows perforated radiant barrier foil with proper air gap and new blown-in insulation below.

A small film production office near Santa Monica Boulevard had a flat roof with dark EPDM rubber absorbing heat all day and radiating it downward until 9 PM. The existing R-19 fiberglass was doing nothing against radiant heat gain. We installed a perforated radiant barrier foil directly to the underside of the roof deck with a 3/4-inch air gap, then blew new Knauf EcoFill fiberglass to R-30 below it. The radiant barrier reflects 97% of radiant heat back toward the roof deck, and the perforations allow moisture to escape. The space now cools to setpoint in 20 minutes instead of 90. Written price: $3,600. The production company has referred three neighboring tenants.

Insulation Removal, Cleaning & Rodent Proofing - 1920s Duplex Near Doheny Drive

Before: contaminated insulation with rodent tunnels and entry gaps in a West Hollywood duplex attic. After: sanitized attic deck with sealed entry points and new Rockwool batts in steel mesh-protected areas.
Insulation removal, attic cleaning, and rodent proofing in a 1920s West Hollywood duplex. Before photo shows contaminated fiberglass with active rodent tunnels and unsealed entry gaps. After photo shows sanitized deck, all entry points sealed with steel mesh and foam, and new Rockwool batts in protected areas.

The owner of a 1920s duplex near Doheny Drive had been trapping rats in the attic for two years. Every exterminator killed what was there; none stopped what came next. We removed all contaminated insulation, found six entry points including a 2-inch gap where a cast-iron vent stack passed through the eave, and one active nest in a soffit corner. We sealed every penetration with steel mesh and polyurethane foam, sanitized the deck with enzyme treatment, and installed Rockwool ComfortBatt in areas vulnerable to re-entry because rodents won’t chew it. Then we blew new cellulose to R-38 everywhere else. The written price was $5,400. Eighteen months later, zero callbacks. The owner received the Documented Photo Record showing every sealed entry point for his warranty file.

Want Results Like These?

Technician installing blown-in attic insulation using industrial equipment
Want Results Like These?

Every job starts with a written price before any work starts, always. No exceptions. We answer calls live at (213) 306-2607, 24/7, and we’ll give you a free second opinion on any written estimate you’ve already received. Wes Okafor or one of our background-checked, uniformed technicians will walk your attic or crawl space, explain what we find in plain language, and leave you with a flat price, a written scope, and a written warranty under the Haven Standard before anyone lifts a tool.

Written by Wes Okafor, Owner at Topside Attic Insulation West Hollywood, serving West Hollywood since 2016.

Need Insulation help in West Hollywood? Licensed & insured · 1-hour response · free estimates
Call (213) 306-2607
Local Service Coverage

Request a Free Estimate in West Hollywood

Tell us what you need - Topside Attic Insulation West Hollywood responds fast. No obligation.

By providing your information above, you accept our Privacy Policy and agree to be contacted by phone, email, or text about your service request, including from the local pros who may handle it.

Prefer to text? Send a Text
Call Now - 24/7 Dispatch