A Topside company - serving West Hollywood, CA

Icynene Home Energy Audit Nationwide

Icynene Home Energy Audit in West Hollywood: What to Know First

We provide independent Icynene home energy audit in West Hollywood, typically completed in a single visit with same-day reporting on most calls. Most audits run between $275 and $595 depending on square footage and the number of conditioned zones tested. We are not affiliated with or authorized by Icynene; we are an independent Icynene service provider that services the product lines already installed in local homes.

Call (213) 306-2607

This page is for West Hollywood homeowners who have Icynene spray foam or open-cell insulation in their attic, walls, or crawl space and need a documented assessment of how it’s performing. Maybe your energy bills climbed after a renovation, or you’re seeing hot spots in rooms that used to stay even. We answer calls live at (213) 306-2607, and every audit starts with a written price before any work starts.

How Icynene Products Fail - and How We Fix Them

  • Icynene Classic Max (open-cell, 0.5 lb/ft³): shrinkage at top plates in West Hollywood’s dry heat. Classic Max can pull back from framing members over years of seasonal cycling, especially in 1960s ranch homes near Melrose where attic temperatures exceed 140°F in August. We map the gaps with thermal imaging, then inject compatible two-part foam to re-establish the air barrier before adding any supplementary insulation.
  • Icynene MD-R-200 (medium-density, 2.0 lb/ft³): delamination from OSB roof sheathing after roof leaks. MD-R-200 bonds aggressively when first applied, but water intrusion from a failed tile or compromised flashing breaks that adhesion. We find the wet zone with moisture meters, remove the compromised foam back to sound substrate, and reapply only after the sheathing reads below 19% moisture content.
  • Icynene LD-C-50 (low-density, 0.4 lb/ft³): dusting and surface degradation in vented attics. The exposed surface of LD-C-50 can degrade when attic ventilation pulls fine particles through the matrix. We see this in bungalows off Santa Monica Boulevard where original gable vents were never sealed during retrofit. Our fix is a full air-sealing pass at the vent penetrations, then a thin protective coating if the foam has begun to dust.
  • Icynene H2Foam Lite (water-blown open-cell): odor complaints after improper curing. H2Foam Lite requires specific substrate temperature and humidity to cure fully; West Hollywood’s occasional Santa Ana wind events can accelerate surface skinning before the core reacts. We test with a simple acetone swab - if it softens the surface, the foam is still reactive - and ventilate or encapsulate as the condition requires.
  • Icynene Classic Max overspray onto recessed can lights: code violation and fire hazard. Early installers in West Hollywood often buried non-IC-rated fixtures in open-cell foam. We cut back to a 3-inch clearance, install proper fire-rated covers, and refoam with a thermal barrier compliant to California Energy Code Title 24. Wes keeps that code book on his truck seat for a reason.

Our Icynene Home Energy Audit Process

Technician installing blown-in attic insulation using industrial equipment
Our Icynene Home Energy Audit Process
  1. 1
    Call and schedule. A live person answers. We ask square footage, Icynene product line if you know it, and what’s prompting the audit. You get a written price range by text before we dispatch.
  2. 2
    Blower-door test on arrival. We pressurize your home to 50 pascals - a standard pressure differential that lets us measure total air leakage in CFM50. This gives us a baseline number that everything else refers back to.
  3. 3
    Thermal imaging and insulation inspection. Our FLIR camera maps temperature differentials across Icynene surfaces. We’re looking for the signature patterns: shrinkage shows as linear cold strips at framing, delamination as blotchy irregularities, overspray as hot spots where foam contacts heat sources.
  4. 4
    Duct leakage test if applicable. Many West Hollywood homes with Icynene also have flex duct in the attic. We seal the registers and pressurize the duct system to 25 pascals, measuring leakage as a percentage of fan flow. Duct leakage above 10% means conditioned air is escaping into the attic, and no amount of wall foam fixes that.
  5. 5
    Written report with photo documentation. You get the blower-door number, thermal images with annotations, moisture readings, and a prioritized scope of work. If we found nothing wrong, the report says so plainly.
  6. 6
    365-Day Done Right Promise on any work performed. Under Haven Standard, if we seal it and the blower-door number doesn’t improve, we reopen the scope and correct it. The written warranty arrives before anyone lifts a tool.
BeforeBefore
AfterAfter

What Icynene Home Energy Audit Costs in West Hollywood

Most Icynene home energy audits in West Hollywood fall between $275 and $595. Here’s what moves you inside that range:

Service Component Typical Range
Single-zone blower-door test with thermal imaging $275 - $375
Multi-zone audit (separate attic + conditioned space testing) $395 - $495
Duct leakage test added to audit $125 - $175
Full building envelope assessment with moisture mapping $495 - $595

Homes above 3,500 square feet or with multiple HVAC systems typically land at the upper end. We also service Reflectix radiant barrier systems if your audit reveals that reflective insulation would complement the Icynene already in place. Every estimate is free, and we offer a Free Second Opinion on any written estimate you’ve already received. Call (213) 306-2607 for an exact quote - estimates are free.

Why West Hollywood Homeowners Call Topside Attic Insulation West Hollywood for Icynene Work

Professional cutting pink fiberglass insulation for attic installation
Why West Hollywood Homeowners Call Topside Attic Insulation West Hollywood for Icynene Work

We’ve been inside more than a few bungalows off Santa Monica Boulevard - air-sealing the top plates before a single bag of cellulose goes in, because that’s the sequence that actually holds an R-value. Seal the leaks first. Then insulate. The R-value on the bag assumes you did it in that order.

Our crew has handled Icynene products since they started appearing in West Hollywood remodels in the early 2010s. We don’t push proprietary materials; we source from Owens Corning, Johns Manville, Knauf, Rockwool, CertainTeed, Icynene, Demilec, and GreenFiber, so our recommendation follows the building science, not a supplier contract. Every job closes with a Documented Photo Record and, on air-sealing work, before-and-after blower-door numbers you can reference when your utility bill arrives. Background-checked, uniformed technicians. Calls answered live, 24/7. No voicemail loops.

Get the price in writing before anything starts.A real person answers, day or night.
Call now

FAQs

Need Insulation help in West Hollywood? Licensed & insured · 1-hour response · free estimates
Call (213) 306-2607
Local Service Coverage

Request a Free Estimate in West Hollywood

Tell us what you need - Topside Attic Insulation West Hollywood responds fast. No obligation.

By providing your information above, you accept our Privacy Policy and agree to be contacted by phone, email, or text about your service request, including from the local pros who may handle it.

Prefer to text? Send a Text
Call Now - 24/7 Dispatch